Piece #5: Above driver's-side door. This was the worst piece from Jim Carter. Not enough material on the sides or on the center rear. The sides should slip under the door windlace.

Piece #5: Front piece, is held in place in the front by slipping under the windshield seal. Note the rear has slipped out of the roof bow (cardboard is too "short". This is the last piece to be installed.

Piece #5: Front piece, above passenger-side door. Not enough cardboard to fit under door windlace. Piece #4: The next headliner piece fit fine (right piece in photo), but there is not enough material in bottom rear corner (on both sides).

Piece #3: Third piece of headliner from front and rear (this is middle piece of five pieces). This piece fit fine.

Piece #3: Middle piece of headliner is on the left. Piece #2: Second from the rear piece of headliner is on the right.

PIece #2: On the left. Piece #1: On the right. Both of these pieces fit fine.

Piece #1: First piece to be installed. Before installing the headliner, be sure that all hardware above the rear doors are in place and adjusted for final fit of doors.

Pieces #1 & #2: Driver's side of Suburban.