HM-rear-mount_1 The rear of my HM-rear-mount_2 Another photo of the rear of the u-joint cover/bell. HM-rear-mount_3 1954 Chevrolet 1/2 ton Hydra-Matic transmission rear mount. This mount came off a H-M drivetrain that I obtained in 1998. HM-rear-mount_4 Bottom of transmission mount. The rubber on the top and bottom is a little rough at the edges but intact in between the plates. HM-rear-mount_5 Another photo of the bottom of the mount. HM-rear-mount_6 The replacement transmission mount went into place quite easily. The original lower right bolt into the bell collar would not grab with the mount in place (the threads in the hole were stripped). Luckily, a 1/2 HM-rear-mount_7 I only cleaned enough to get the mount in place. A thorough cleaning will take place during restoration. You can see the spacer washers on the lower right bolt on the collar. HM-rear-mount_8 Sorry about the poor focus. I then tighened the collar at the rear of the u-joint cover. Unfortunately, I cannot drive the truck until I get two broken exhaust pipe studs removed from the exhaust manifold (as Rosanne Rosanna Dana used to say . . .

This album has 8 items in total    |    Album was updated 6/23/06 12:52 PM    |    Generated by JAlbum 6.4, custom skin ExhibitPlus 1.4a